In need of advice on how to get rid of a tree stump? You may make it quick and easy by following these steps, or you can hire a tree stump removal expert, such as Garden Pro (visit website).
In spite of the fact that we may get paid or earn an affiliate compensation if you make a purchase after clicking on one of our links, all editorial products are chosen without bias. All ratings and prices are current, and all listed items are in stock.
Introduction
Learn how to get rid of a tree stump without straining your back by reading this article. This approach is risk-free, produces excellent results, and needs little to no physical effort on your part. However, patience is required. The whole thing may take a few weeks.
Needed Equipment
- Bit lengthening by 12 inches
- Ax
- Pruner on a cord
- To lengthen an existing cable
- Armour-plated ears
- Remover of roadblocks (optional)
Needed Components
- Substances intended to dissolve a stub
- Water
Make Baby Steps Toward Your Goals (4)
Step 1
Prepare the Stump by Drilling Holes in It
- The top of the stump should be cut off as completely as possible with the chainsaw.
- Drill holes approximately every 6 to 8 inches all the way around the stump using a 1-inch spade bit and spade bit extension. Dig the holes 12 inches in, then space them out 3 to 4 inches from the perimeter.
- Add more holes to the drill At a 45-degree angle, drill down three to four inches from the rim to link up with the initial holes. Check that the intersection of the lower holes with the vertical ones is at an angle greater than 90 degrees and that the distance between the two is more than 12 inches. Doing so prevents any spillage of the chemicals you intend to pour in from above.
- Those slanted openings at the bottom can be used as smoke vents or as entryways for rot.
Step 2
Fill the holes with chemical stump removers.
- After filling the holes with water, apply 3 to 4 ounces of granular tree stump remover chemical to each hole.
- A chemical treatment of the stump will hasten its decomposition over the course of four to six weeks. The stump will soften and become sponge-like when this occurs.
- Epsom salt stump removal is a more natural option.
- Get a sharp falling axe and hack out the rotten timber.
Step 3
If you’re stuck, try a Power Stump Grinder.
- Get rid of a stump quickly by renting a motorised stump grinder.
Step 4
Do away with the tree’s roots.
- Putting kerosene or fuel oil (never gasoline) in the holes is one method that some makers of tree stump removal chemicals recommend for getting rid of the remnants of the stump.
- Hold off until the liquid has fully soaked into the wood (this could take a few weeks). The next step is to light the holes with a match.
- After several days of burning, the stump will leave behind a charcoal void.
- Having a gigantic ember in your yard can be dangerous, so it’s important to take the proper safety measures. Wrap the stump in chicken wire, clear the area of leaves, and keep a close eye on the fire. If the stumps are in an area where a garden hose might be useful, keep water on hand in case the fire spreads.
- If you’re worried about your safety, you should use an axe to do the task. Don’t forget that you can’t remove a freshly cut tree stump by hand; only seasoned (older) stumps that have been dead for a year or more will break down enough for manual removal.
