If your furnace’s igniter is clicking, but the burner does not ignite, there are a few possible reasons. First, check to see if debris is blocking the gas flow. Then, ensure that the igniter gap is set correctly; if it is too far from the burner, it will not be able to create a spark. Finally, try cleaning the igniter with a stiff brush. If none of these solutions works, you may need to replace the igniter. Fortunately, this is a relatively simple and inexpensive repair. Once you have replaced the igniter, your furnace should be up and running again.
A faulty furnace ignitor will usually look darker than a normal one. It may also be chipped or cracked. If the ignitor is very old, it may be covered in rust. If you see any of these signs, it is best to replace the ignitor as soon as possible. A faulty ignitor can cause your furnace to malfunction like a furnace clicking, leading to significant repair bills. It can also be dangerous, as a malfunctioning furnace can produce carbon monoxide gas. Therefore, it is vital to keep an eye on your ignitor and replace it if necessary.
A furnace that clicks could have any issues, but troubleshooting tips can help you identify the problem. First, check to see if the furnace is receiving power. If the furnace is not receiving power, check the circuit breakers and make sure that the power switch is in the ‘On’ position. The next step is checking the pilot light to see if the furnace gets power. If the pilot light is out, relight it following the manufacturer’s instructions. If the pilot light does not stay lit, there may be an issue with the thermocouple. Finally, if the furnace is still clicking after you have checked all of these things, there is likely a problem with the blower motor. Call a qualified technician to diagnose and repair the problem.
Before you begin resetting your furnace’s ignitor, it is vital first to understand what an ignitor is and how it works. The furnace ignitor is a small ceramic rod that emits a high-voltage spark that ignites the furnace’s gas burner. Over time, the ignitor can become cracked or coated with dirt and debris, which means it will not be able to create the necessary spark. As a result, the furnace will be unable to heat your home. If you find yourself in this situation, do not despair! Resetting your furnace ignitor is a relatively simple process that only requires a few tools and a bit of know-how.
First, start by turning off the power to your furnace at the breaker box. Next, locate the ignitor and remove it from the furnace. Once the ignitor is removed, carefully inspect it for any cracks or debris. If you find any damage, it is best to replace the entire ignitor rather than try to repair it. However, if the ignitor looks clean and intact, you can try resetting it by gently bending the ceramic rod back into place. Once the rod is straightened, reattach the ignitor to the furnace and turn on the power. With any luck, your furnace should now be up and running!
